Click image to enlarge

Drive Key Spindle Gauges
When inserted in the spindle, the "go" gauge should be in contact with the plane face. The "no go" gauge should not contact the face. Two measuring gauges in storage case:...
Details PDF

Dial Indicator Tool Taper Gauges
Both measuring gauges are set to zero with the calibrated taper plug gauge. When an HSK tool holder is inserted in the ring gauges, deviations in diameters d2 or d3 are shown...
Details PDF

Steep Taper Tool Changer Alignment Gauges
Available for Steep Taper 30, 40, 50, and 60
Details PDF

Dial Indicator Spindle Taper Gauges
To ensure sustained accuracy at HSK interfaces, we recommend comparison measuring of the geometry of HSK tool shanks and spindles at regular intervals. These checks should...
Details PDF

Electronic Tool Taper Gauges
The four transducers mounted in the measuring ring are used for differential measurement of gauge dimensions d2 and d3. Deviations from the calibrated taper plug gauge are...
Details PDF

Pneumatic Spindle Taper Gauges
Non-contact measuring with nozzles results in high accuracy and consistency of measuring results. The measuring range can be increased with the built-in dial indicator. This...
Details PDF

Tool Holder Taper Sleeve Gauges
Available for Steep Taper 30, 40, 45, 50, 55, 60, 65
Details PDF

Laip Steep Taper (MAS 403 BT) to Steep Taper (DIN 2080) Reducing Adapters
Converts Steep Taper (MAS 403 BT) to Steep Taper (DIN 2080)
Details PDF

HSK Tool Changer Alignment Gauges
Available for HSK-A 25, 32, 40, 50, 63, 80, 100, 125, and 160
Details PDF